284 Power over Ethernet Commands
power inline traps enable
The power inline traps enable Global Configuration mode command enables inline power traps. Use the
no form of this command to disable inline power traps.
Syntax
• power inline traps enable
• no power inline traps
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enables inline power traps to be sent when a power usage threshold is exceeded.
show power inline
The show power inline User EXEC mode command displays the information about inline power.
Syntax
•
show power inline [interface
interface
]
•
interface —
Valid Ethernet port. (Full syntax:
unit/port
)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# power inline traps enable
book.book Page 284 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
