114 Address Table Commands
Example
The following example displays all static entries in the bridge-forwarding database.
show bridge address-table count
The show bridge address-table count Privileged EXEC mode command displays the number of addresses
present in the Forwarding Database.
Syntax
•
show bridge address-table count
[
vlan
vlan
][
ethernet
interface-number
|
port-channel
port-channel-
number
]
•
vlan
— Specifies a valid VLAN, such as VLAN 1.
•
interface —
A valid Ethernet port
.
•
port-channel-number
— A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console# show bridge address-table static
Aging time is 300 sec
vlan mac address port type
---- ----------------- ---- -----------------
1 00:60:70:4C:73:FF 1/e8 Permanent
1 00:60:70:8C:73:FF 1/e8 delete-on-timeout
200 00:10:0D:48:37:FF 1/e9 delete-on-reset
book.book Page 114 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
