Dell PowerConnect 3524

Management ACL 245
Management ACL
management access-list
The management access-list Global Configuration mode command configures a management
access list and enters the Management Access-list Configuration command mode. Use the no form
of this command to delete an access list.
Syntax
• management access-list name
• no management access-list name
• name — Access list name. (Range: 1-32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• Use this command to configure a management access list. The command enters the Access-list
Configuration mode, where permit and deny access rules are defined using the
permit
(Management)
and deny (Management) commands.
• If no match criteria are defined, the default is deny.
• If you re-enter an access list context, the new rules are entered at the end of the access list.
• Use the
management access-class command to select the active access list.
• The active management list cannot be updated or removed.
• Management ACL requires a valid management interface, which is a port, VLAN, or port channel
with an IP address or console interface. Management ACL only restricts access to the device for
management configuration or viewing.
book.book Page 245 Thursday, December 18, 2008 7:40 PM