Dell PowerConnect 3524

404 Syslog Commands
logging buffered
The logging buffered Global Configuration mode command limits syslog messages displayed from an
internal buffer based on severity. Use the no form of this command to cancel using the buffer.
Syntax
• logging buffered level
• no logging buffered
• level — Specifies the severity level of messages logged in the buffer. Possible values: emergencies,
alerts
, critical , errors, warnings , notifications, informational, debugging.
Default Configuration
The default severity level is informational.
Command Mode
Global Configuration mode.
User Guidelines
All the syslog messages are logged to the internal buffer. This command limits the messages displayed to
the user.
Example
The following example limits syslog messages displayed from an internal buffer based on severity level
debugging.
logging buffered size
The logging buffered size Global Configuration mode command changes the number of syslog messages
stored in the internal buffer. Use the no form of this command to return to the default configuration.
Syntax
• logging buffered size number
• no logging buffered size
• number — Specifies the maximum number of messages stored in the history table. (Range: 20 -
400)
Default Configuration
The default number of messages is 200.
Console(config)# logging buffered debugging
book.book Page 404 Thursday, December 18, 2008 7:40 PM