504 Web Server
Default Configuration
The default port number is 443.
Command Mode
Global Configuration mode.
User Guidelines
Specifying 0 as the port number effectively disables HTTPS access to the device.
Example
The following example configures the https port number to 100.
ip https exec-timeout
The ip https exec-timeout Global Configuration command sets the interval the system waits for user
input before automatically logging off. Use the no form of this command to return to default.
Syntax
•
ip https exec-timeout
minutes
[
seconds
]
• no ip https exec-timeout
Parameters
•
minutes
— Integer that specifies the number of minutes. (Range: 0 - 65535)
•
seconds
— Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is the exec-timeout that was set by the ip http exec-timeout command.
Command Mode
Global Configuration mode.
User Guidelines
This command also configures the exec-timeout for HTTPS in case the HTTPS timeout was not set. To
specify no timeout, enter the command ip https exec-timeout 0 0.
Console(config)# ip https port 100
book.book Page 504 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
