518 802.1x Commands
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following example enables periodic re-authentication of the client.
dot1x timeout re-authperiod
The dot1x timeout re-authperiod Interface Configuration mode command sets the number of seconds
between re-authentication attempts. Use the no form of this command to return to the default
configuration.
Syntax
•
dot1x timeout re-authperiod
seconds
• no dot1x timeout re-authperiod
•
seconds —
Number of seconds between re-authentication attempts. (Range: 300 - 4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e16
Console(config-if)# dot1x re-authentication
book.book Page 518 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
