EasyManua.ls Logo

Dell PowerConnect 3524

Dell PowerConnect 3524
538 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SNMP Commands 345
Syntax
snmp-server host
{
ip4-address | ip6-address | hostname} community-string
[
traps | informs] [1 | 2
]
[udp-port
port
] [
filter
filtername
] [
timeout
seconds
] [
retries
retries
]
no snmp-server host
{
ip4-address | ip6-address | hostname}
[
traps | informs
]
ip4-address
— The host IPv4 address (the targeted recipient).
ip6-address
— The host IPv6 address (the targeted recipient). When the IPv6 address is a Link
Local address (IPv6Z address), the outgoing interface name must be specified. Refer to the usage
guidelines for the interface name syntax.
hostname
— Specifies the name of the host. (Range:1 - 158 characters)
community-string
— Specifies a password-like community string sent with the notification
operation. (Range: 1 - 20)
traps
— Indicates that SNMP traps are sent to this host. If unspecified, SNMPv2 traps are sent to
the host.
informs
— Indicates that SNMP informs are sent to this host. Not applicable to SNMPv1.
1
— Indicates that SNMPv1 traps will be used.
2
— Indicates that SNMPv2 traps will be used. If
port
— Specifies the UDP port of the host to use. If unspecified, the default UDP port number is
162. (Range: 1 - 65535)
filtername
— Specifies a string that defines the filter for this host. If unspecified, nothing is
filtered. (Range: 1 - 30 characters)
seconds
— Specifies the number of seconds to wait for an acknowledgment before resending
informs. If unspecified, the default timeout period is 15 seconds.
(Range: 1 - 300)
retries
— Specifies the maximum number of times to resend an inform request. If unspecified, the
default maximum number of retries is 3. (Range: 0 - 255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
When configuring an SNMPv1 or SNMPv2 notification recipient, a notification view for that recipient
is automatically generated for all the MIB.
When configuring an SNMPv1 notification recipient, the
Inform
option cannot be selected.
book.book Page 345 Thursday, December 18, 2008 7:40 PM

Table of Contents

Related product manuals