Delta AH500 - Page 10

vi
5.5.2 Start Addresses for Analog Input/Output Modules ........................... 5-18
5.4.3 Start Addresses for Temperature Measurement Modules ............... 5-19
5.4.4 Start Addresses for Motion Control Modules.................................... 5-19
5.4.5 Start Addresses for Network Modules .............................................. 5-20
Chapter 6 Writing a Program
6.1 Quick Start................................................................................................. 6-2
6.1.1 Example ............................................................................................. 6-2
6.1.2 Hardware ........................................................................................... 6-2
6.1.3 Program ............................................................................................. 6-2
6.2 Procedure for Creating a Project in ISPSoft .............................................. 6-3
6.3 Creating a Project ..................................................................................... 6-4
6.4 Hardware Configuration ............................................................................ 6-5
6.4.1 Configuring a Module ......................................................................... 6-5
6.4.2 Setting the Parameters in a CPU Module and a Module .................... 6-7
6.5 Creating a Program ................................................................................... 6-9
6.5.1 Adding a Ladder Diagram .................................................................. 6-9
6.5.2 Basic Editing─Creating a Contact and a Coil ................................... 6-11
6.5.3 Basic Editing─Inserting a Network and Typing an Instruction .......... 6-14
6.5.4 Basic Editing─Selection of a Network and Operation ...................... 6-16
6.5.5 Basic Editing─Connecting a Contact in Parallel ............................... 6-18
6.5.6 Basic Editing─Editing a Comment ................................................... 6-19
6.5.7 Basic Editing─Inserting an Applied Instruction ................................. 6-20
6.5.8 Basic Editing—Creating a Comparison Contact and Typing a Constant .
......................................................................................................... 6-22
6.5.9 Writing a Program ............................................................................ 6-23
6.5.10 Checking and Compiling a Program ................................................ 6-24
6.6 Testing and Debugging a Program ......................................................... 6-25
6.6.1 Creating a Connection ..................................................................... 6-25
6.6.2 Downloading a Program and Parameters ........................................ 6-28
6.6.3 Connection Test ............................................................................... 6-31
6.7 Setting a Real-time Clock ........................................................................ 6-37