AH500 Hardware and Operation Manual
6-18
6.5.5
Basic Editing
-
Connecting a Contact in Parallel
(1) Click on the toolbar, and then move the mouse cursor to the input contact in network 2. The mouse
cursor will appear as a contact. Move the mouse cursor to the button of the input contact in network 2.
After the mouse cursor appears as , users can click the left mouse button. A contact will be connected
to the input contact in network 2 in parallel.
(2) Write the program in network 2 shown below in the way described above.
Additional remark
After users select a group of contacts, they can connect a contact to the group of contacts in the way
described above.
To Next Page
Loading...
