Delta AH500 - 11.2.2.6 Downloading the Parameters Related to an Ether Link

AH500 Hardware and Operation Manual
11-46
11.2.2.6 Downloading the Parameters Related to an Ether Link
After the parameters related to an Ether Link are set, users have to download the parameters to PLCs. The
PLCs can perform data exchange after the parameters are downloaded.

Single node
Only the data demanding setting related to the PLC selected, the start mode of the PLC selected, and the
start modes of the modules connected to the PLC are downloaded. Before the users download the related
parameters, they have to make sure that the system connects to the PLC normally, and they have
completed the communication setting in NWCONFIG. Please refer to section 20.1.3 from ISPSoft User
Manual for more information.

Method 1
Select a data demanding node, and then click
on the toolbar. The users can also download the
related parameters by selecting a data demanding node, clicking the PLC menu, pointing to Transfer,
and clicking Download (Single PLC).

Method 2
Select a data demanding node, right-click the data demanding node, and click Download (Single
PLC) on the context menu.