AH500 Hardware and Operation Manual
8.1.3.8 Ethernet – Advance: Email
Select the Email Function Enable checkbox, and then set the related parameters for the email-related
functions.
Select Email Function Enable to enable the function and then start setting the following parameters.
Set an IP address of SMTP server. Set the COM port of SMTP server at the COM port and set the
sender’s email box at local email address. Type a mail subject as the start of the subject of every
email.
Select Account identification checkbox to enable the function. Users can set to authenticate
themselves with a user name and a password before logging in to an SMTP server.
Type the target email address of a receiver.
Type a trigger name in Trigger Name box and a minimum interval in Trigger Min Cycle in the Trigger
Setting table. And then select a trigger condition on the drop-down list. When the sending condition is met, the
system will send an email every a period of time. But the same email will not be sent again within the set
interval.
To Next Page
Loading...
