AH500 Hardware and Operation Manual
12-86
12.4.4
AH05PM-5A/AH10PM-5A/AH15PM-5A
Error code Description
The subroutine has no data.
CJ, CJN, and JMP have no matching pointers.
There is a subroutine pointer in the main program.
The pointer is used repeatedly in the same program.
The subroutine pointer is used repeatedly.
16#A008
The pointer used in JMP is used repeatedly in different
subroutines.
Blinking
16#A009
The pointer used in JMP is the same as the pointer used in
Blinking
The pointer used in JMP is the same as a subroutine pointer.
Target position (I) of the single speed is incorrect.
Target position (II) of the single-axis motion is incorrect.
The setting of speed (I) of the single-axis motion is incorrect.
The setting of speed (II) of the single-axis motion is incorrect.
The setting of the speed (V
RT
) of returning to zero is incorrect.
16#A010
The setting of the deceleration (V
CR
) of returning to zero is
incorrect.
Blinking
The setting of the JOG speed is incorrect.
16#A012
The positive pulses generated by the single-axis clockwise
motion are inhibited.
Blinking
16#A013
The negative pulses generated by the single-axis
counterclockwise motion are inhibited.
Blinking
The limit switch is reached.
The device which is used exceeds the device range.
16#A017
An error occurs when the device is modified by a 16-bit index
register/32-bit index register.
Blinking
The conversion into the floating-point number is incorrect.
16#A019
The conversion into the binary-coded decimal number is
incorrect.
Blinking
Incorrect division operation (The divisor is 0.)
LD/LDI has been used more than nine times.
16#A01D
There is more than one level of nested program structure
supported by RPT/RPE.
Blinking
SRET is used between RPT and RPE.
16#A01F
There is no M102 in the main program, or there is no M2 in the
motion program.
Blinking
16#A020
The wrong instruction is used, or the device used exceeds the
Blinking
To Next Page
Loading...
Need help?
General
