Delta AH500 - 6.5.10 Checking and Compiling a Program

AH500 Hardware and Operation Manual
6-24
6.5.10 Checking and Compiling a Program
After users write a program, they can check the syntax of the programming language or compile the program.
The syntax and the structure in the present window will be checked after the Check function is enabled. The
whole project will be checked after the Compile function is enabled. If there is no error in the project, an
execution code will be generated automatically. After the program is compiled successfully, the mother line at
the left side of the ladder diagram will become black.
 Check
Click Check on the Compile menu, or on the toolbar.

C
ompile
Click Compile on the Compile menu, or on the toolbar.
After the check is complete, the Compile Message page shows the result related to the check. If there is any
error in the project, the Compile Message page will show the related message. After the message is clicked,
the system will automatically lead users to the place where the error occurs. The users can enable the Check
function or the Compile function after the error is eliminated.