Delta AH500 - Page 106

Chapter 2 Specifications and System Configuration
2-73
 AH10DNET-5A
IN 1
IN 0
DR 1
DR 0
10DNET
Node Address
x10
0
x10
1
NS
MS
1
12
2
3
4
7
6
8
9
11
10
5
Number
Name
Description
1
Model name
Model name of the module
2
Seven-segment
display
Display
3
Address knobs
Setting the address
4
Function switch
Setting the functions
5
DeviceNet connector
DeviceNet is used to interconnect control devices for data exchange.
6
MS LED indicator
Indicating the status of the module
7
NS LED indicator
Indicating the status of the network
8
Removable terminal
block
Terminals for wiring
9
Label
Nameplate
10
Set screw
Fixing the module
11
Connector
Connecting the module and a backplane.
12
Projection
Fixing the module
1. Address knobs
It is used to set the node address of AH10DNET-5A on a DeviceNet network. (Node addresses range
from 0 to 63.)
Setting
Description
0…63
Available nodes on a DeviceNet
network
64…99
Unavailable nodes on a
DeviceNet network
Example: If users want to set the communication address of AH10DNET-5A to 26, they can turn the
knob corresponding to x10
1
to 2, and turn the knob corresponding to x10
0
to 6.
Points for attention:
 When the power supply is cut off, the node address is set. After the setting of the node address
is complete, AH10DNET-5A can be supplied with power.
 If AH10DNET-5A is running, changing the node address is unavailable.
 Please use a slotted screwdriver to turn the knobs with care, and do not scrape them.