AH500 Hardware and Operation Manual
9-14
configuration in NWCONFIG. Besides, the users can directly connect network modules to the DVP series
PLCs in the NWCONFIG window.
There are two ways to add a network module to the working area.
Method 1
Select a network module on the device list, and then drag it to a PLC in the working area.
If the PLC does not support the network module selected, the mouse cursor becomes .
An AH10EN series module can only be put on a main backplane. Eight AH10EN series modules at most
can be put on a main backplane. An AH10SCM series module can be put on an extension backplane. The
number of AH10SCM series modules which can be put on a backplane depends on the number of slots on
the backplane.
Users can choose a backplane to which an AH10SCM series module is dragged.
After the users drag an AH10SCM series module to at the right side of a node, an extension rack will
be added to the node.
To Next Page
Loading...
