Chapter 11 Convenient Functions
11-27
2. Example:
The master station AHCPU530-RS2 is connected to slave station 1 DVP28SV11T. The data in the device
addresses starting from D300 in slave station 1 is read into the device address starting from D100 in the
master station. The number of data read from slave station 1 is 10. The data in the device addresses
starting from D0 in the master station is written into the device addresses starting from D300 in slave
station 1. The number of written into slave station 1 is 10. SM1598 is set to OFF, SM1595 is set to OFF,
and SM1586 is set to ON. Users can check whether data exchange is preformed correctly by comparing
the data in D0~D9 with the data in D100~D109 in the master station.
Method 1:
Users can set the parameters related to a PLC Link according to the process described above.
Step 1: Start ISPSoft, and write the program shown below. If M1 is turned ON, SM1586 and SM1584 will
be ON.
To Next Page
Loading...
