AH500 Hardware and Operation Manual
11-86
Item Description
Floating format setting
Floating point setting; round down; default: round the number down to
Device
Devices to be monitored; read only
Radix
Positional numeral system to be shown on the monitoring page; available
formats are Signed decimal, Unsigned decimal, Hexadecimal, Octal,
Binary, 32bit Signed decimal, 32bit Unsigned decimal, 32bit
Hexadecimal, 32bit Octal, 32bit Binary, 32bit Float and 64bit Double
Description
Add a description here for the table; read only
Status
Status of bit; read only
Green LED: ON; No LED: OFF
Value
Values in devices to be monitored; read only
Signed decimal: K+ Number
Unsigned decimal: K+ Number
Hexadecimal: H + hex Number
Octal: O + octal Number
Binary: B + binary Number
32bit Signed decimal: K+ Number
32bit Unsigned decimal: K+ Number
32bit Hexadecimal: H + hex Number
32bit Octal: O + octal Number
32bit Binary: B + binary Number
32bit Float: float Number
64bit Double: float Number
“On” / ”Off”
“ON”: the status of Bit is ON.
“OFF”: the status of Bit is OFF.
If the authority level for the logged in user is READ, this column is
read only.
Set Value
Change the value for the device to be monitored
Type the value in and click “SET” and the changed value appears in
the VALUE column as the image shown above.
If the authority level for the logged in user is READ, this column is
“Set”
Click “Set” to confirm the changed value.
If the authority level for the logged in user is READ, this column is
read only.
To Next Page
Loading...
