Dynon Avionics SkyView HDX - No GPS; Stuck Mic; External Flip;Flop

MAP and VFR GPS Navigator Operation
SkyView HDX Pilot’s User Guide – Revision B 5-33
Each tab in the bar of tabs at the top of the Nearest window contains a list of aviation features,
they include:
• APT – Airport
• WX – Weather (when a weather device is connected)
• VOR
• NDB
• FIX – Fixes
• VRP – Visual Reporting Points
• USR – User Waypoints
• ATC – Nearest non-airport specific ATC-frequencies (Centers). Available with FAA
aviation data only.
• FSS – Nearest FAA Flight Service Station frequencies. Available with FAA aviation data
only.
Map Items which are set to Off in the MAP ITEMS menu, such as private airports or seaplane
bases, will not appear in the nearest list at all.
To view data under each tab, either touch the tab name or push-and-hold the CURSR knob
while rotating to move a secondary blue cursor left and right among the tabs. Rotate the CURSR
knob up/down to highlight different items in the list. Once the desired facility is shown, press
INFO for more information about it, to navigate directly to it, or ADD->FPL to add it as a
waypoint in a Flight Plan. Items that have Com frequencies associated with them can have their
frequencies sent to a connected Com radio by pressing TUNE COM.
Nearest Airports List Filter and Other Options
You can also apply additional criteria to the list of nearest airports with the FILTER button,
which replaces the NRST button when the list is displayed. SkyView will remember if the filter
was selected when it was powered off and automatically filter the list again on the next bootup.
To see the full list of airports, press the FILTER button again.
To configure the filter, go to MAP SETUP > NEAREST LIST OPTIONS (press-and-hold Buttons 7+8,
then selecting MAP SETUP > NEAREST LIST OPTIONS):
• SHOW FULL AIRPORT NAME – Yes/No, turns the full airport name on or off regardless if
FILTER is engaged or not.
• WHEN FILTERED – The following restrictions are applied to the nearest list when FILTER
option is active:
o RUNWAY SURFACE – You can choose to display Any Surface, Water only, Hard
and Soft or Hard only when FILTER is engaged.
o PRIVATE AIRPORTS – You can choose to Show or Not Show private airports when
FILTER is engaged.