Enterasys Matrix E1 1G694-13

Spanning Tree Configuration
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G694-13) Configuration Guide 5-15
5.2.1.10 set spantree edgeportdelay
Use this command to enable or disable the edge port delay function, which causes an edge port to
delay (by 2 “hello” periods) moving to a forwarding state.
set spantree edgeportdelay {disable | enable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable Spanning Tree edge port delay:
disable | enable Disables or enables edge port delay.
Matrix>set spantree edgeportdelay disable
Success setting edge port delay to DISABLE.