Enterasys Matrix E1 1G694-13

Spanning Tree Configuration
Reviewing and Setting Spanning Tree Port Parameters
5-28 Matrix E1 Series (1G694-13) Configuration Guide
5.2.2.4 set spantree portpri
Use this command to set a port’s priority for use in the Spanning Tree algorithm (STA).
set spantree portpri port_string priority
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to set the priority of front panel port 3 to 128:
NOTE: Path cost (set spantree portcost) takes precedence over port priority.
port_string Specifies the port(s) for which to set Spanning Tree port
priority. For a detailed description of possible port_string
values, refer to Section 4.1.2.
priority Specifies a number that represents the priority of a link in
a Spanning Tree bridge. Valid values are from 0 to 240 (in
increments of 16) with 0 indicating high priority and 240,
low priority.
Matrix>set spantree portpri ge.0.3 128
Spanning tree port priority set to 128 for port ge.0.3.