Spanning Tree Configuration
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G694-13) Configuration Guide 5-17
5.2.1.12 set spantree legacypathcost
Use this command to enable or disable legacy (802.1D) path cost values.
set spantree legacypathcost {disable | enable})
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1D:
disable | enable Disables or enables legacy (802.1D) path cost values.
Matrix>set spantree legacypathcost enable
Legacy path cost ENABLED.