Port Priority Configuration
Configuring Priority to Transmit Queue Mapping
7-6 Matrix E1 Series (1G694-13) Configuration Guide
7.2.2 Configuring Priority to Transmit Queue Mapping
Purpose
To display and set the current priority to transmit queue mapping of each port.
Commands
The commands used in configuring transmit port priority queues are listed below and described in
the associated section.
• show priority queue (Section 7.2.2.1)
• set priority queue (Section 7.2.2.2)
7.2.2.1 show priority queue
Use this command to display the current port priority levels (0 through 7, with 0 as the lowest
priority) associated with the current transmit port priority queue (0 -3, with 0 being the lowest
priority). A frame with a certain port priority is transmitted according to the settings entered using
the set priority queue command described in Section 7.2.2.2.
show priority queue [priority]
Syntax Description
Command Defaults
If priority is not specified, all priority information will be displayed.
Command Mode
Read-Only.
priority (Optional) Specifies a value of 0 - 7 to display the
mapping of the priority to a transmit queue.
To Next Page
Loading...
Need help?
General