Enterasys Matrix E1 1G694-13

Spanning Tree Configuration
Reviewing and Setting Spanning Tree Port Parameters
5-24 Matrix E1 Series (1G694-13) Configuration Guide
5.2.2 Reviewing and Setting Spanning Tree Port Parameters
Purpose
To display and set Spanning Tree port or module parameters, including enabling or disabling the
Spanning Tree algorithm on one or more ports, displaying blocked ports, displaying and setting
Spanning Tree port priorities and costs, configuring edge port parameters, and setting point-to-point
protocol mode.
Commands
The commands needed to review and set Spanning Tree port parameters are listed below and
described in the associated section as shown.
• set spantree portadmin (Section 5.2.2.1)
• show spantree blockedports (Section 5.2.2.2)
• show spantree portpri (Section 5.2.2.3)
• set spantree portpri (Section 5.2.2.4)
• show spantree portcost (Section 5.2.2.5)
• set spantree portcost (Section 5.2.2.6)
• show spantree adminedgeport (Section 5.2.2.7)
• set spantree adminedge (Section 5.2.2.8)
• show spantree adminpoint (Section 5.2.2.9)
• set spantree adminpoint (Section 5.2.2.10)