Enterasys Matrix E1 1G694-13

Port Configuration
Setting Port Auto-Negotiation
4-16 Matrix E1 Series (1G694-13) Configuration Guide
4.2.3.2 set port negotiation
Use this command to enable or disable auto-negotiation on one or more ports.
set port negotiation port_string {disable | enable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable auto-negotiation on Gigabit Ethernet front panel port 11:
port_string Specifies the port(s) for which auto-negotiation will be
enabled or disabled. For a detailed description of possible
port_string values, refer to Section 4.1.2.
disable | enable Disables or enables auto-negotiation.
Matrix>set port negotiation ge.0.11 disable
Auto negotiation disabled for port ge.0.11.