Startup and General Configuration
Setting Basic System Information
Matrix E1 Series (1G694-13) Configuration Guide 3-11
3.2.2 Setting Basic System Information
Purpose
To display and set the basic system information, including time, contact name, terminal output,
baud rate and version information, to display or set the local host IP address, and to download a
new firmware image to the device.
Commands
The commands needed to set basic system information are listed below and described in the
associated section as shown.
•show system (Section 3.2.2.1)
•show time (Section 3.2.2.2)
• set time (Section 3.2.2.3)
• show version (Section 3.2.2.4)
• set system name (Section 3.2.2.5)
• set system location (Section 3.2.2.6)
• set system contact (Section 3.2.2.7)
• set terminal (Section 3.2.2.8)
• set system baud (Section 3.2.2.9)
• show ip address (Section 3.2.2.10)
• set ip address (Section 3.2.2.11)