IGMP Configuration
Reviewing IGMP Groups
8-10 Matrix E1 Series (1G694-13) Configuration Guide
8.2.3 Reviewing IGMP Groups
Purpose
Use this command to display the status of IGMP groups on the switch. This includes the VLAN
port configured to transmit IGMP multicast transmissions, its VLAN ID, and the IP addresses of
the ports asking to receive those transmissions as part of the IGMP group.
Command
The command used to display IGMP groups is listed below and described in the associated section
as shown.
• show igmp groups (Section 8.2.3.1)
8.2.3.1 show igmp groups
Use this command to display a list of IGMP streams and client connection ports.
show igmp groups
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.
Examples
This example shows how to display IGMP groups. In this example, the switch knows to forward
all multicast traffic for IP address 224.47.239.73 to Gigabit Ethernet front panel ports 2, 7, 9, and
11.
Matrix>show igmp groups
Vlan Id = 1 MultiCast IP = 224.47.239.73 Type = IGMP
IGMP Port List = ge.0.2, ge.0.7, ge.0.9, ge.0.11
-----------------------------------------------------------------
Multicast group list processed.
To Next Page
Loading...
Need help?
General