Spanning Tree Configuration
Reviewing and Setting Spanning Tree Bridge Parameters
5-18 Matrix E1 Series (1G694-13) Configuration Guide
5.2.1.13 show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
show spantree tctrapsuppress
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display the status of topology change trap suppression:
Matrix>show spantree tctrapsuppress
Topology change trap suppression is currently enabled.
To Next Page
Loading...
Need help?
General