IGMP Configuration
Setting IGMP Query Count and Report Delay
Matrix E1 Series (1G694-13) Configuration Guide 8-7
8.2.2.2 set igmp query count
Use this command to set the number of minutes that must elapse before the switch removes a port
from an IGMP group.
set igmp query count size
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to set the IGMP query count to 8 minutes:
size Specifies the time in minutes for the switch to continue
sending IGMP queries.
Matrix>set igmp query count 8
IGMP query count set to 8.
To Next Page
Loading...
Need help?
General