Enterasys Matrix E1 1G694-13 - Set Igmp

IGMP Configuration
Enabling / Disabling IGMP
8-4 Matrix E1 Series (1G694-13) Configuration Guide
8.2.1.2 set igmp
Use this command to enable or disable IGMP snooping on the switch. This allows a host to inform
the switch it wants to receive transmissions addressed to a specific multicast group.
set igmp {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Examples
This example shows how to enable IGMP snooping on the switch:
This example shows how to disable IGMP snooping on the switch:
enable | disable Enables or disables IGMP snooping on the switch.
Matrix>set igmp enable
IGMP Snooping is enabled.
Matrix>set igmp disable
IGMP Snooping is disabled.