Enterasys Matrix E1 1G694-13

Startup and General Configuration
Setting SNMP Traps
3-30 Matrix E1 Series (1G694-13) Configuration Guide
3.2.5 Setting SNMP Traps
Purpose
To assign IP addresses where SNMP traps will be sent. The device can send messages to multiple
network management stations to alert users of status changes. For details on the types of traps this
device supports, refer to the appropriate Matrix E1 Release Notes.
Commands
The commands needed to set SNMP traps are listed below and described in the associated section
as shown.
•show trap (Section 3.2.5.1)
• set trap (Section 3.2.5.2)
• clear trap (Section 3.2.5.3)