Enterasys Matrix E1 1G694-13

Network Management
Managing General Device Settings
9-2 Matrix E1 Series (1G694-13) Configuration Guide
9.2.1.1 clear config
Use this command to clear the user-defined configuration parameters stored in NVRAM. This
resets the device back to its factory default settings. For a list of default settings for this device,
refer to Section 3.1.1.
clear config
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to clear the device’s NVRAM configuration parameters:
Matrix>clear config
This command will clear NVRAM.
Do you want to continue (y/n) [n]? y
Keep the IP setting (y/n) [n]? n
Clearing NVRAM...
Reset the board to get the new settings.