Startup and General Configuration
Setting SNMP Traps
Matrix E1 Series (1G694-13) Configuration Guide 3-31
3.2.5.1 show trap
Use this command to display SNMP trap configuration information.
show trap
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only
Example
This example shows how to use the show trap command. It shows that there are two SNMP traps
enabled. One is assigned to the “orange” community at IP address 1.2.3.4. Another is assigned to
the “blue” community at IP address 100.54.5.112.
Matrix>show trap
Community Name IP Address Status
-------------------- --------------- --------
orange 1.2.3.4 enabled
blue 100.54.5.112 enabled
public 0.0.0.0 disabled
public 0.0.0.0 disabled
public 0.0.0.0 disabled
To Next Page
Loading...
Need help?
General