Enterasys Matrix E1 1G694-13 User Manual

IGMP Configuration
Setting IGMP Query Count and Report Delay
Matrix E1 Series (1G694-13) Configuration Guide 8-5
8.2.2 Setting IGMP Query Count and Report Delay
Purpose
To display and set IGMP query count and report delay settings. These commands work together to
remove ports from an IGMP group. Query count specifies the time in minutes that must elapse
before the switch removes the port from an IGMP group. Report delay specifies the number of
queries that must be missed before the IGMP report delay timer is started.
Commands
The commands needed to display and set IGMP query count and report delay are listed below and
described in the associated sections as shown.
• show igmp query count (Section 8.2.2.1)
• set igmp query count (Section 8.2.2.2)
• show igmp report delay (Section 8.2.2.3)
• set igmp report delay (Section 8.2.2.4)

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English