Enterasys Matrix E1 1G694-13 User Manual

Startup and General Configuration
Setting the Login Password
3-10 Matrix E1 Series (1G694-13) Configuration Guide
3.2 GENERAL CONFIGURATION COMMAND SET
3.2.1 Setting the Login Password
Purpose
To change the login password on the CLI.
Command
The command needed to set the login password is listed below and described in the associated
section as shown.
• set password (Section 3.2.1.1)
3.2.1.1 set password
Use this command to set the login password on the CLI.
set password {rw | ro}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to set an initial Read-Write password:
rw | ro Sets the password to Read-Write or Read-Only.
Matrix>set password rw
Enter old password: ********
Enter new password: ********
Retype new password: ********
Password changed.

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English