Port Priority Configuration
Configuring Quality of Service (QoS)
Matrix E1 Series (1G694-13) Configuration Guide 7-9
7.2.3 Configuring Quality of Service (QoS)
Purpose
To configure one or more ports with the following Layer 2 switching features:
• Four priority queues on each port.
• Programmable scheduling according to weighted round-robin (in percentage of traffic per
queue).
Command Descriptions
The commands to configure the Quality of Service are listed below and described in the associated
section.
• show port qos (Section 7.2.3.1)
• set port qos wrr (Section 7.2.3.2)
To Next Page
Loading...
Need help?
General