Startup and General Configuration
Starting and Navigating the Command Line Interface
3-6 Matrix E1 Series (1G694-13) Configuration Guide
3.1.6.2 Logging in with a Default User Account
If this is the first time your are logging in to the Matrix E1 Series device, or if the default user
accounts have not been administratively changed, proceed as follows:
1. At the Username login prompt, enter one of the following default user names:
• ro for Read-Only access,
• rw for Read-Write access.
2. Press ENTER. The Password prompt displays.
Leave this string blank and press ENTER. The notice of authorization and the Matrix prompt
displays as shown in Figure 3-3.
Figure 3-2 Console Port Initial Startup Screen Before User Authorization
(c)Copyright ENTERASYS Networks, Inc. 2001
Matrix 1G694-13
POST Version ver 01.00.08
Loading primary functional image ... PASSED
Application image loaded to CPU SDRAM.
Starting Application ...
1G694-13
Switch init start...
Switch SOC init...
Switch 10G PHY init...
Starting Boot......Press Ctrl-c to enter Diagnostics mode
Initializing hardware ...
Switch clear VLAN table...
Switch init finished...
Initializing databases...
Username:
To Next Page
Loading...
Need help?
General