Enterasys Matrix E1 1G694-13

Port Configuration
Setting Port Traps
Matrix E1 Series (1G694-13) Configuration Guide 4-25
4.2.6.2 set port trap
Use this command to enable or disable an SNMP link trap on one or more ports.
set port trap port_string {enable | disable}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable the SNMP link trap for Gigabit Ethernet front panel port 3:
port_string Specifies the port(s) for which a trap will be enabled on
disabled. For a detailed description of possible port_string
values, refer to Section 4.1.2.
enable | disable Enables or disables a trap on the specified port.
Matrix>set port trap ge.0.3 disable
SNMP link traps disabled for port ge.0.3