802.1Q VLAN Configuration
Enabling/Disabling GVRP (GARP VLAN Registration Protocol)
Matrix E1 Series (1G694-13) Configuration Guide 6-27
Commands
The commands used to configure GVRP are listed below and described in the associated section as
shown.
• show gvrp configuration (Section 6.2.6.1)
• set gvrp (Section 6.2.6.2)
• set gvrp timer (Section 6.2.6.3)
6.2.6.1 show gvrp configuration
Use this command to display GVRP configuration information, including timer values, GVRP
global status, and GVRP port status.
show gvrp configuration port_string
Syntax Description
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display GVRP information:
port_string Specifies which port(s) will have GVRP configuration
information displayed. For a detailed description of
possible port_string values, refer to Section 4.1.2.
Matrix>show gvrp config ge.0.5-10
Port based GVRP Configuration: (Timer units are centiseconds)
Port Number Join Leave Leaveall GVRP Status
----------- ---------- ---------- ---------- -----------
ge.0.5 20 60 1000 enabled
ge.0.6 20 60 1000 enabled
ge.0.7 20 60 1000 enabled
ge.0.8 20 60 1000 enabled
ge.0.9 20 60 1000 enabled
ge.0.10 20 60 1000 enabled
To Next Page
Loading...
Need help?
General