Enterasys Matrix E1 1G694-13

Port Configuration
Setting Port Auto-Negotiation
Matrix E1 Series (1G694-13) Configuration Guide 4-15
4.2.3.1 show port negotiation
Use this command to display the status of auto-negotiation for one or more ports.
show port negotiation [port_string]
Syntax Description
Command Defaults
If port_string is not specified, auto-negotiation status for all ports will be
displayed.
Command Mode
Read-Only.
Example
This example shows how to display auto-negotiation status on the Gigabit Ethernet front panel
port 5:
port_string (Optional) Specifies the port(s) for which
auto-negotiation status will be displayed. For a detailed
description of possible port_string values, refer to
Section 4.1.2.
Matrix>show port negotiation ge.0.5
Auto negotiation enabled for port ge.0.5