Spanning Tree Configuration
Reviewing and Setting Spanning Tree Port Parameters
Matrix E1 Series (1G694-13) Configuration Guide 5-29
5.2.2.5 show spantree portcost
Use this command to display cost values assigned to one or more Spanning Tree ports.
show spantree portcost port_string
Syntax Description
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display the port cost for front panel port 3. In this case, the 0 value
indicates that the port has been set to use its default value when operating in a Spanning Tree:
port_string Specifies the port(s) for which to display cost values. For a
detailed description of possible port_string values, refer to
Section 4.1.2
.
Matrix>show spantree portcost ge.0.3
Port cost = 0 for port ge.0.3.
NOTE: This command displays values set using set spantree portcost as described in
Section 5.2.2.6. A value of 0 indicates that the device will use the default STP cost value
assigned to the port when operating in a Spanning Tree. Use the show spantree stats
[port port-string] command as described in Section 5.2.1.1 to display the actual port
cost values currently in use.
To Next Page
Loading...
