802.1Q VLAN Configuration
Reviewing Existing VLANs
Matrix E1 Series (1G694-13) Configuration Guide 6-3
6.2 VLAN CONFIGURATION COMMAND SET
6.2.1 Reviewing Existing VLANs
Purpose
To see a list of the current VLANs (dynamic and static) configured on the device, their VLAN type,
and the ports on the VLAN egress list. The device uses the VLAN egress list to keep track of all
VLANs that it will recognize.
Commands
The commands needed to configure static VLANs are listed below and described in the associated
section as shown.
• show vlan (Section 6.2.1.1)
• show vlan static (Section 6.2.1.2)
NOTE: Static VLANs are those VLANs created manually -- using the commands
described in this section, SNMP, or WebView.
To Next Page
Loading...
Need help?
General