Network Management
Monitoring Network Events and Status
Matrix E1 Series (1G694-13) Configuration Guide 9-15
9.2.2.7 show netstat
Use this command to display statistics for the device’s active network connections.
show netstat [icmp | interface | ip | routes | stats | tcp | udp]
Syntax Description
Command Defaults
If no parameters are specified, show netstat will be executed as shown in the
example below.
Command Mode
Read-Only.
Example
This example shows how to display statistics for all the current active network connections:
Table 9-2 provides a detailed explanation of the command output.
tcp (Optional) Shows Transmission Control Protocol (TCP)
statistics.
udp (Optional) Shows User Datagram Protocol (UDP)
statistics.
ip (Optional) Shows Internet Protocol (IP) statistics.
icmp (Optional) Shows Internet Control Message Protocol
(ICMP) statistics.
routes (Optional) Shows the IP routing table.
stats (Optional) Shows all statistics for TCP, UDP, IP, and
ICMP.
interface (Optional) Shows interface statistics.
Matrix>show netstat
Active Internet connections (including servers)
PCB Proto Recv-Q Send-Q Local Address Foreign Address (state)
-------- ----- ------ ------ ------------------ ------------------ -------
1cc6314 TCP 0 0 0.0.0.0.80 0.0.0.0.0 LISTEN
1cc6104 TCP 0 0 0.0.0.0.23 0.0.0.0.0 LISTEN
1cc6290 UDP 0 0 0.0.0.0.162 0.0.0.0.0
1cc620c UDP 0 0 0.0.0.0.161 0.0.0.0.0
To Next Page
Loading...
Need help?
General