Port Configuration
Setting Flow Control
4-18 Matrix E1 Series (1G694-13) Configuration Guide
4.2.4.1 show port flowcontrol
Use this command to display the flow control state for one or more ports.
show port flowcontrol [port_string]
Syntax Description
Command Defaults
If port_string is not specified, flow control statistics for all ports will be displayed.
Command Mode
Read-Only.
Example
This example shows how to display the port flow control state for Gigabit Ethernet front panel
ports 1 through 4. It shows that auto-negotiation is enabled on ports 1 and 4 (therefore, flow
control cannot be enabled on these ports). It also shows that flow control is disabled on port 2, and
enabled on port 3.
port_string (Optional) Specifies the port(s) for which flow control
state will be displayed. For a detailed description of
possible port_string values, refer to Section 4.1.2.
Matrix>show port flowcontrol ge.0.15-18
Port ge.0.1 flow control state is auto negotiate.
Port ge.0.2 flow control state is disabled.
Port ge.0.3 flow control state is enabled.
Port ge.0.4 flow control state is auto negotiate.
To Next Page
Loading...
Need help?
General