Startup and General Configuration
Setting SNMP Community Names
3-28 Matrix E1 Series (1G694-13) Configuration Guide
3.2.4.2 set community
Use this command to set SNMP community names and access policies.
set community community_name access_ policy
Syntax Description
Command Defaults
None.
Command Mode
Read-write.
Example
This example shows how to set the community name “green” for read-write access.
community_name Specifies the name through which a user will access
SNMP management. Up to 5 community names can be
set.
access_ policy Specifies the access permission accorded each
community name. The available access levels are:
• read-only (ro): This community name gives the user
read-only access to the device MIB objects, and
excludes access to security-protected fields of
read-write authorization.
• read-write (rw): This community name gives the user
read-write access to the device MIB objects and also
allows the user to change all modifiable parameters,
including community names, IP addresses, traps and
SNMP objects.
Matrix>set community green rw
Community record added.
To Next Page
Loading...
