Enterasys Matrix E1 1G694-13

Network Management
Managing Network Addresses and Routes
9-28 Matrix E1 Series (1G694-13) Configuration Guide
9.2.3.4 show ip route
Use this command to display IP routing table entries.
show ip route
Syntax Description
None.
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display the IP routing table.
Table 9-4 provides a detailed explanation of the command output.
Matrix>show ip route
destination gateway flags Refcnt Use Interface
----------------------------------------------------------------------------
90.0.1.0 90.0.1.0 0 2 host.0.1
127.0.0.1 127.0.0.1 UH 0 8 host.0.1
----------------------------------------------------------------------------
Table 9-4 show ip route Output Details
Output What It Displays...
destination Destination address IP route mask.
gateway IP address of the gateway router.
flags Route status; possible values are U=up,
G=route to a Gateway, H=route to a host.
Use Number of times a route entry was used to route packets.
Interface Type of interface.