802.1Q VLAN Configuration
Reviewing Existing VLANs
6-6 Matrix E1 Series (1G694-13) Configuration Guide
6.2.1.2 show vlan static
Use this command to display all information related to one or more static VLAN(s) known to the
device. Static VLANs are those VLANs that you have manually created using this command set,
SNMP MIBs, or the WebView management application.
show vlan static [vlan_id]
Syntax Description
Command Defaults
If vlan_id is not specified, information for all static VLANs will be displayed.
Command Mode
Read-Only.
Example
This example shows that the static VLAN 7 has the name green and is enabled to operate. Gigabit
Ethernet front panel ports 5 through 7, 9 and 11 are in the VLAN 7 port egress list and configured
to transmit frames tagged as VLAN 7 frames.
vlan_id (Optional) Specifies the number of the VLAN to be
displayed.
Matrix>show vlan static 7
VLAN: 7 Name: green Status: enabled
Egress Ports
ge.0.5-7, ge.0.9, ge.0.11
Forbidden Egress Ports
None
Untagged Ports
None
To Next Page
Loading...
Need help?
General