Startup and General Configuration
“Command Defaults” Descriptions
Matrix E1 Series (1G694-13) Configuration Guide 3-3
3.1.2 “Command Defaults” Descriptions
Each command description in this guide includes a section entitled “Command Defaults” which
contains different information than the factory default settings on the device as described in
Table 3-1. The command defaults section defines CLI behavior if the user enters a command
without optional parameters (indicated by square brackets [ ]). For commands without optional
parameters, the defaults section lists “None”. For commands with optional parameters, this section
describes how the CLI responds if the user opts to enter only the keywords of the command syntax.
Figure 3-1 provides an example.
Figure 3-1 Sample Command Default Description
Spanning Tree transmit
hold count
Set to 3.
Spanning Tree version. Set to rstp (Rapid Spanning Tree Protocol).
System baud rate Set to 9600 baud.
System contact Set to sysContact.
System location Set to sysLocation.
System name Set to sysName.
Terminal CLI display set to 80 columns and 24 rows.
VLAN ID All ports use a VLAN identifier of 1, and are included on the host
VLAN ID 1 port VLAN list.
WebView Enabled.
WebView port Set at TCP port number 80.
show port status [port_string]
Command Defaults
If port_string is not specified, status information for all ports
will be displayed.
Table 3-1 Factory Default Device Settings (Continued)
Device Feature Default Setting
To Next Page
Loading...
Need help?
General