Port Configuration
Setting Port Auto-Negotiation
4-14 Matrix E1 Series (1G694-13) Configuration Guide
4.2.3 Setting Port Auto-Negotiation
Purpose
To determine whether auto-negotiation is enabled or disabled for the specific port and to set the
state, and to display or set a port’s advertised mode of operation. During auto-negotiation, the port
“tells” the device at the other end of the segment what its capabilities are.
Commands
The commands needed to configure auto-negotiation are listed below and described in the
associated section as shown.
• show port negotiation (Section 4.2.3.1)
• set port negotiation (Section 4.2.3.2)
To Next Page
Loading...
Need help?
General