Enterasys Matrix E1 1G694-13

Port Configuration
Setting Port Trunking
4-30 Matrix E1 Series (1G694-13) Configuration Guide
4.2.10 Setting Port Trunking
Purpose
To display trunking information, to create and delete trunks on the device, and to display and
configure port settings for a particular trunk.
Commands
The commands needed to configure port trunking are listed below and described in the associated
section as shown.
• show trunk (Section 4.2.10.1)
• set trunk (Section 4.2.10.2)
• clear trunk (Section 4.2.10.3)
• set trunk port (Section 4.2.10.4)
• clear trunk port (Section 4.2.10.5)