Enterasys Matrix E1 1G694-13 User Manual

Startup and General Configuration
Factory Default Settings
3-2 Matrix E1 Series (1G694-13) Configuration Guide
Does not apply to MATRIX
Password None configured. User must press ENTER at password prompt to
access CLI.
Port auto-negotiation Disabled.
Port enable/disable Enabled.
Port trap Link traps for all ports are enabled.
QoS weighted
round-robin (WRR)
Set to 25% for weighted queues (0 through 3).
Spanning Tree Enabled (globally and on all ports).
Spanning Tree edge
port administrative
status
Enabled.
Spanning Tree edge
port delay
Enabled.
Spanning Tree forward
delay
Set to 15 seconds.
Spanning Tree hello
interval
Set to 2 seconds.
Spanning Tree ID
(SID)
Set to 1.
Spanning Tree legacy
path cost
Enabled.
Spanning Tree
maximum aging time
Set to 20 seconds.
Spanning Tree port cost Set to 1 for both 1-Gigabit and 10-Gigabit Ethernet ports.
Spanning Tree port
priority
All 1-Gigabit ports are set to 128 (medium priority). The 10-Gigabit
uplink port is set to 112.
Spanning Tree priority Bridge priority is set to 32768.
Table 3-1 Factory Default Device Settings (Continued)
Device Feature Default Setting

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English